Lower Case Switcher Seriale
Working on configuring new C9300 switches. In the getting started guide for configuration it indicates I can plug PC into any unmanaged network port on the switch and use the WEBUI site at 192.168.1.1 to configure the switch. The PC must be configured for DHCP and it should get an IP from the switch.This is not working and looking to see if there is a service to start on the switch.I can connect to the switch console port and access the cli. Limited CLI experience and would prefer the GUI to configure the switch.
Uppercase Word
Did you already access the CLI and say 'No' to the initial configuration message?It may have stopped the day 0 configuration and just left you with a blank config.Have you tried rebooting it and then connecting only to a network port with your computer? You may also have to log in to the switch via CLI and issue the 'write erase' command and reboot it without saving the config to get it back to the day 0 prompt.Otherwise have you tried giving your PC a static IP in the 192.168.1.x range and then try accessing the webUI? Hidid you wait 3 minutes for the DHCP?From the official guide to Webgui 9300 belowProcedureStep 1Make sure that no devices are connected to the switchStep 2Connect one end of an ethernet cable to one of the uplink (non-management) ports on the active supervisor and the other end of the ethernet cable to the host (PC).Step 3Set up your PC as a DHCP client, to obtain the IP address of the switch automatically.It may take up to three mins. You must complete the Day0 setup through the WebUI before using the device terminal.Step 4Launch a Web browser on the PC and enter the device IP address in the address bar.